Ruud / Rheem 3-Ton Air Handler R-410A Single Stage with Variable Speed ECM Motor, 208/240V, 1 Ph, 60 Hz

The Rheem/Ruud RH1V Air Handler includes an energy efficient ECM Motor, which in most applications, enhances the SEER rating of the outdoor unit. It also slowly ramps its speed up for quiet operation and enhanced customer satisfaction. The Rheem/Ruud RH1V comes in a versatile 4-way convertible design for upflow, downflow, horizontal left and horizontal right applications. Also, it has a nominal airflow up to 1.0 external static pressure. It comes with a factory-installed indoor coil.

Standard Features:
 

• Quiet, efficient ECM motor technology providing nominal airflow up to 1.0 inch [25 kPa] of external static pressure.
• Interface board with dip switches conveniently located in the blower compartment allows for precise, field selectable air-flow to meet the requirements of particular applications.
• Selectable continuous fan on options.
• The most compact unit design available.
• Attractive pre-painted cabinet exterior.
• Rugged steel cabinet construction, designed for added strength and versatility.
• 1.0 foil faced insulation mechanically retained in blower compartment.
• Four leg rubber insulated motor mount.
• Field-installed auxiliary heater kit includes circuit breakers that meet UL and cUL requirements as a service disconnect switch.
• Blower housing with integrated controls, motor and blower.
• Slide out design for service and maintenance convenience.
• Field convertible for vertical upflow, vertical downflow, horizontal left hand or right-hand air supply.
• Combustible floor base accessory available when required for downflow installations on combustible floors.
• Indoor coil design provides low air side pressure drop, high-performance and extremely compact size. All coils come withPVC condensate elbow standard

Cabinet Features:
 

• Coils are constructed of aluminum fins bonded to internally grooved aluminum tubing.
• Coils are tested at the factory with an extensive refrigerant leak check.
• Coils have copper sweat refrigerant connections.
• Coils utilize chatleff metering device connections.
• Molded polymer corrosion resistant condensate drain pan is provided on all indoor coils.
• Supply duct flanges provided as standard on air handler cabinet.
• Provisions for field electrical connections available from either side or top of the air handler cabinet.
• Connection point for high voltage wiring is inside the air handler cabinet.
• Low voltage connection is made on the outside of the air handler cabinet.
• Concentric knockouts are provided for power connection to cabinet.
• Installer may pull desired hole size up to 2 inches, 51 mm, for 1 1/2 inch, 38 mm conduit.
• Front refrigerant and drain connections.

•  
• Parts List
   
• Warranty Document
   
• Consumer Literature 3
   
• Consumer Literature
   
• Installation Instructions
   
• Specification Sheet
   
• Wiring Diagrams